• Free Samples

  To receive your free floor marking samples please fill in the information to the right make sure we have the most accurate information to quickly get you the samples in a timely manner.

Free Samples

• Test before you purchase
• Find the best tape for your money
• Use the tape that actually works for you

Get Started Here!

For free samples fill in the information below, just fill out our form!

Name:
Company:
Email:
Address:
City:
State:	- Please Select - Alabama Alaska Arizona Arkansas California Colorado Connecticut Delaware District of Columbia Florida Georgia Hawaii Idaho Illinois Indiana Iowa Kansas Kentucky Louisiana Maine Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico New York North Carolina North Dakota Ohio Oklahoma Oregon Pennsylvania Rhode Island South Carolina South Dakota Tennessee Texas Utah Vermont Virginia Washington West Virginia Wisconsin Wyoming - CANADA - Alberta British Columbia Manitoba New Brunswick Newfoundland Northwest Terr. Nova Scotia Nunavut Ontario Prince Edward Island Quebec Saskatchewan Yukon Terr.
Zip:
Phone:

    

More information on the Floor Marking

Tips for Floor Marking
OSHA Regulations require that permanent aisles and passageways must be adequately marked. ANSI Z535.2 Safety Color Code designates Yellow as the caution color to be used for marking physical hazards such as stumbling, falling or tripping points, as well as aisles and paths of egress. Industrial Floor Marking Tapes are usually recognized as the most convenient and inexpensive way to mark aisles since painted lines tend to chip, peel and crack especially in areas with heavier traffic.

Aisle Width
OSHA's general requirement for aisles and passageways is that "sufficient safe clearances" must be provided where mechanical equipment is used. The width required will vary depending upon how the aisle is utilized in the workplace- as aisleways that utilize forklift and truck traffic will need to be wider than aisles for pedestrian traffic. A good average size is 36 inches. Additionally, inside storage rooms containing flammable and combustible liquids, aisles must be at least three feet wide, and for emergency exit access points, 28 inches is the mini- mum allowed width.

Tape Width
The required minimum width for facility aisle and floor marking lines is 2"- therefore any width above that is considered acceptable by OSHA and ANSI. Typical applications use tape in 2" - 6" width.

We're Here To Help!
If you have any questions regarding floor marking regulations or products, please give us a call or send us an email- we'd be glad to assist you! We can be reached M-F, toll-free at (866) 777-1360, or via email: [email protected]