1-866-777-1360M-F 6am - 4:30pm PST
SafetyTac® Dots - Floor Marking Shapes
- Durable, low profile PVC material
- Peel & stick application
- Forklift, traffic, chemical, UV, water, wear resistant
- 4 sizes available
SafetyTac® Dots can assist with organizational, 5S, and safety efforts. They are typically used to mark boundaries. You can also use them in high-traffic locations where tape lines struggle to hold up. If a forklift or pallet tears one dot off the floor, it’s much easier to replace that dot than it is to replace an entire run of tape. SafetyTac® Dots are made using the same high-quality, industrial material as our SafetyTac® tape, which means they can withstand forklift and truck traffic. They will also hold up to water, chemicals, and UV rays. These dots are easy to install, so you won’t need to worry about downtime during installation. They also have a low profile so they won’t interfere with your facility’s operations.
SafetyTac® Shapes sit smoothly on floors and won’t snag or cause tripping.
Easy to Install
Just peel off the backing and stick the tape to a clean, dry surface.
Resistant to Traffic
SafetyTac® Shapes can hold up to heavy foot and vehicle traffic.
Perfect floor markers
Posted by Unknown on 9th Oct 2013
These were perfect for making indicators on the floor that made it clear where the children are supposed to stand and wait. We used to mark them with paint and we would have to re-paint once a month. These have been down for about four months and still look new.